Topic: Which ECU programmer can read and write VW Bosch EDC17C64?
Here is the suggestion from eobdtool.co.uk engineer.
PCMTuner ECU Programmer can perform virtual reading, writing, and checksum correction for VAG EDC17C64 on bench and via OBD without issue.
Some customers are worried that there is a risk to writing with PCMTuner.
Actually, it’s safe to use PCMTuner. The software is the same as the original pcmflash, they just cloned the dongle and nothing changed in the software. With an original scanmatik inside, it’s safe like the original.
If you read and write no problem, but the control unit has fault codes and cannot start the car. The possible cause is the bad checksum, which must be done in winols, especially if using Dpf/EGR off software.
How to read and write VW EDC17C64 ECU by PCMTuner?
i.e. VW Golf 2.0 TDI EDC17C64
Run pcmflash software
Select the corresponding protocol and connect EDC17 to pcmtuner on bench mode following the wiring diagram
Select Module 71 ECU protocol
Correct checksums automatically
Verification… erase area… transfer data…
All are successful.
Foxflash can read and write via OBD to EDC17C64 complete with checksum correction.
i.e. AUDI A3 8V 1.6/2.0 16V TDI 105/150.184CV BOSCH EDC17C64
foxFlash software can be download on official website: https://www.dfb-technology.com
Open foxflash manager and keep running
Open foxflash software to select driver, car maker, and ECU model
Connect foxflash ecu programmer and ecu correctly according to the wiring diagram
Write file/recovery and correct checksum- success
Learn more info:
foxFlash Super ECU TCU Clone & Chiptuning Tool Full Version:
FoxFlash for Sales: (Valid: April 1st-30th)
Now Buy foxflash in April can get free two gifts
1) Toyota/Lexus BDM Jtag Solder for free (first 500pcs)
2) T-Shirt with Foxflash Logo(first 1000pcs)
V1.27 PCMtuner ECU Programmer with 67 Modules