Audi MED17.1 ECM Clone and Mileage Correction with OBDSTAR DC706

OBDSTAR DC706 ECU Tool can read and write INT Flash and INT EEPROM, read IMMO data, decrypt IMMO Data, convert (clone) INT EEPROM Data, calibrate mileage to AUDI MED17.1 TC1796 ECM by Bench and MP001 or P003/P003+ mode. You don’t need to connect a 120-ohm resistor if you use the MP001 connection. It’s easier and safer.

 

Preparation:

OBDSTAR DC706

OBDSTAR MP001 Programmer

Bench –A V3 Clone Jumper

Main cable

12V/5A power supply (DC)

AUDI MED17.1 TC1796 ECM

 

Operation guide:

Select ECU Flasher>> ECM>> ECM V30.80>> med17.1>> AUDI BOSCH MED17.1 TC1796

Check the wiring diagram and follow it to connect DC706 ECU Tool and AUDI ECM via the MP001 Programmer and cables properly

After connection, select Bench and MP001 mode

Make sure DC706 and internet connection is good

Start to perform the available functions below.

• Connect

• Read INT EEPROM, and save the data after reading

• Read INT Flash, and save the data after reading

• INT EEPROM Data Convert

Load the new ECU INT Flash, old (original) ECU INT EEPROM and INT Flash data

Save the data after converting

• Write INT EEPROM

Select the converting EEPROM data to write into the module

• Write INT Flash

Select the INT Flash data to write

• Read IMMO Data

Read out VIN, PinCode, CS and MAC

• Mileage Calibration

Identify the original mileage, and then input the new mileage you desire to change

Calibrate mileage successfully

 

Attachment:

OBDSTAR DC706 Car List for Audi ECM (ECM V30.80)