Customer problem: When I used foxflash ecu programmer to read and write ECU, the software suddenly crashed. I restarted the software to try again, but still appeared the same problem. Eobdtool.co.uk engineer’s solution: Please follow the steps below to… Continue Reading
One customer failed to download Foxflash software and got the error “Unhandled exception in the application. If you click Continue, the application ignores this error and attempts to continue. If you click Exit. The application will close immediately. Could not… Continue Reading
The newest software of CG100 Prog III is updated to V6.7.3.0 on Aug.29th, 2023. Here share the related update info and the available mega link to download free. CG100 PROG III V6.7.3.0 free download link: https://mega.nz/folder/3CIXXDJC#jJ4CdJ9T-eEYhkBYi6Z65A/file/DG53CA5I Update details: 1.Added 44… Continue Reading
If this is your first time using Launch X-431 ECU & TCU Programmer for ECU/TCU reading/writing, data processing, anti-theft shutdown or file verification, please follow this post to download, install, update, and activate the device step by step before operation.… Continue Reading
Here is the newest customer feedback about Foxflash ECU Chip Tuning Tool. edc15 P+ BENCH Flash & eeprom Start EDC15C3 (bench)– from Renault Laguna/ Read/Write OK EDC15C13 (bench) — from Espace IV/ Read/ Write OK EDC15C4 Full Flash R/W OK… Continue Reading
Use the Launch X-PROG3 PC Adaptor and X431 X-Prog3 to clone Infiniti VGS2-FDCT gearbox computer on bench, works like a charm! Here is the operation process: Connect the X-PROG3 PC ADAPTOR to the computer using a USB cable, and… Continue Reading
This post will use different ECU programmers to read the original EEPROM & Flash data and write them into a new BMW E84 CAS3 module, and check which one is better to choose. Issue: The BMW E84 car with… Continue Reading
OBDSTAR DC706 ECU Tool with P003 Adapter Kit can read/write EEPROM/Flash, and read IMMO data on VW 7GV & 9GV ECMs on bench successfully. 1.OBDSTAR DC706 R/W VW 7GV ECM on BENCH 2.OBDSTAR DC706 R/W VW 9GV ECM… Continue Reading
Some customers gave feedback that Foxflash Bench Box stopped working recently. The possible cause is the relay didn’t send 12v to ECU or the P channel mosfet burned. Check the corresponding solutions below. Case 1: The relay didn’t send… Continue Reading
Customer problem: I want to use Foxflash ECU programmer to read and write MPC 55x/56x in BDM/Jtag mode. But when I run foxflash software, there is an error pops up “We remind you that your subscription is about to expire.… Continue Reading
Launch X431 ECU & TCU Programmer new tutorial: Work with X-PROG3 Adapter Cable 2 (VL381) to clone Audi AL381 gearbox TCU on PC software, easy and fast! (Launch X-Prog3 PC Adapter with X-Prog3 also can perform it.) Here is… Continue Reading
