Magic Motorsport Flex version 8.17.0.0 now supports Boot Glitch operations on Mercedes Bosch MD1CP001 and MG1CP002 ECUs with SPC5777 processors through Korhex and EMFI technology. The update allows technicians to access supported Mercedes ECUs without soldering the PCB or removing components. What’s New… Continue Reading
The latest Magic Motorsport Flex update extends motorcycle ECU coverage to Marelli MBC1 and MBC2 control units. With version 8.14.0.0, you can now work on select BMW Motorrad and Husqvarna models directly using Bench mode. This update removes the need to open the ECU. By… Continue Reading
Magic Motorsport has released Flex software update version 8.13.0.0. This update allows you to program VAG Group Bosch MG1CS111 ECUs equipped with the TriCore TC298 processor directly in Bench mode using Boot Glitch unlocking. You do not need to send the ECU to an… Continue Reading
Magic Motorsport Flex ECU Programmer released a world exclusive update: bench mode solution for modern Bosch MD1 MG1 control units found in BMW and Mini vehicles. Technicians can now connect directly through the pinout to read, write and back up internal Flash and… Continue Reading
If you are working on modern B48, B57, and B58 engines, unlocking the encrypted Bosch MD1 or MG1 ECU with Tricore Aurix TC2xx microprocessors (TC298 / TC299) is a straightforward process when using Magic Motorsport FLEX. The procedure follows two… Continue Reading
Magic Motorsport Flex users can now unlock locked Bosch MD1 MG1 ECUs directly using Boot mode, eliminating external RFT service dependencies for bench reading and writing. Technical Overview This protocol enables direct Boot mode unlocking on Bosch MDG1 Engine Control Units equipped with Tricore… Continue Reading
OBDSTAR X300 Classic G3/DC706, Xhorse Multi-Prog, Flex, and Autotuner are capable of reading and writing data for Toyota Generation 3 (R7F701216) Denso ECUs, but they operate through different methods (Bench or OBD) and require specific hardware setups. Check the comparison details below. … Continue Reading
If you’re working on a 2022+ Volkswagen Group vehicle with DQ381 (or DQ380/DQ500) Gen2 gearbox, you’ve likely run into the infamous BH1G0401 bootloader. This security lock has made mileage correction and tuning difficult for many tools. The good news? Several… Continue Reading
Both Magic Motorsport Flex and AutoTuner programmers now support the Bosch MD1CS069 ECU via OBD protocol for the Iveco Daily, making ECU tuning faster and easier for commercial vehicle specialists. Flex Update V7.49.0.0 The latest update for Magic Motorsport Flex… Continue Reading
Issue Encountered: A diagnostic reading was performed on a 2018 Renault Master (1.6L diesel, 95hp, EDC17C84 ECU) using a Magic Motorsport Flex ECU programmer via OBD. The reading process itself completed without error. However, after writing (flashing) the data back to the ECU,… Continue Reading
Question: After 1 year, if I don’t buy license for Flex, I can still use it? And after 2-3 years example, if I want to update, hope I don’t need to pay for all those years i didn’t pay? EOBDTool.co.uk engineer’s Answer: 1.If… Continue Reading
