For VW MQB D70F35xx dashboard key matching and mileage adjustment, it needs to read the original data to calculate. With CG100X programmer, you can change the mileage easily, no need to cut wire and lift feet! Just need to short circuit two Pins!
Here takes 2018 VW Passat as an example.
The current mileage is 123563 km.
The chip is BGA type, and it’s D70F3532.
Run CG100X software
Select Dashboard>> European car>> Volkswagen D70F35xx>> MQB>> D70F3532 (A2C81589500)
Follow the wiring diagram to connect
Use the Pro Adaptation line to connect the dashboard and CG100X host
Short-circuit the two pins as shown in the figure below
Click “Start operation”
Read and save the original data
CG100X will automatically analyze the mileage and modify
The current KM is detected automatically.
Enter the new mileage value manually (i.e.53456), and click “OK”
Modifying KM…
Writing….
The modification is completed.
There is no need to click “write”. Disconnect the Pro Adaptation cable and the two pins, and install the dashboard back on the vehicle.
Now the new KM on the dashboard is 53456 km, it’s the same as the value in the CG100X software.
VW MQB D70F35xx dashboard mileage correction with CGDI CG100X programmer is successful.