Should I buy CG100 PROG III for Honda? Some users asked in the forum. Here shares my experience. Hope it will help you out.
I bought a new CG100 for my Honda off EOBDTOOL last week.
If you are interested it, you can get at good price from
http://www.eobdtool.co.uk/wholesale/cg100-prog-iii-airbag-restore-devices.html
CG100 PROG III highlights:
- Original make, with Full Authorization, support update online
- Including All Function of RENESAS
- SRS and XC236x FLASH
- 4. Support reading and writing EEPROM, support non-secure BMW DDME ECU microcontroller.
- CG100 with built-in calculator, support calculate ISN, VIN and program CRC EEPROM
The software full supports for CPU airbag computer repair and can used on operating systems software: XP/WIN7/WIN8/32bit/64bit.
The test:
Model: Honda
No.: 77960-T9A-F411-M2
Chip: R5F2154
Step 1: Remove and Check the airbag computer
Turn off the vehicle switch
Remove the airbag computer
Check the style and the chip
Step 2: Wire cables with CG100 PROG
Open the CG100 special software
Enter the corresponding operation interface: Airbag> Honda> 77960-T9A-M411-M2
Wire according to the wiring diagram
Confirm the wiring is correct and CG100 prog is powered on
Step 3: Repair Honda airbag
Reading airbag data, pls don’t disconnect…
Note: Please do not touch any cables when it is reading.
Save the data to desktop
Save file successfully
Prompt “Whether to remove the collision fault code”
Then click on “YES”
The airbag is being repaired, please don't disconnect…
Note: Please do not touch any cables when it is repairing.
Repair Honda airbag in process until success
Put the airbag computer back to the car
Test successfully
Done!
