Here is a simple way to read Bosch MED17.8.10 ECU data on bench using Xhorse Multi-Prog and GODIAG guidebook.
Preparation:
- Xhorse Multi-Prog ECU Programmer
- GODIAG Xhorse MultiProg Mastering Programming Book
- GODIAG ECU GPT Boot AD
- BOSCH MED17.8.10 ECU
- Windows PC
Procedure:
Open Multi Prog book, you can see the introduction about Multi-Prog device and accessories
Connect Multi Prog to GODIAG ECU GPT Boot Adapter and PC using the corresponding cables properly
In the book, navigate to 2.7 ECU Data Reading & Writing and Cloning Practice-> 2.7.2 MED17.8.10
That is in page 381
Use ECU GPT Boot Adapter to connect ECU correctly according to the wiring diagram in the book
Complete ECU connection
Go to [Read the data] step
Follow the step-by-step guide inside the book to operate with Multi Prog software
1.Click Device-> Search “med17.8.10”-> Select “ALL_BOSCH MED17.8.10 TC1767 (MG-> Rattan)”-> click “OK”
2.Click the red box remarked diagram to view the “Device Detail” of this memory chip
3.Click Connect, then click Read to save the ECU memory data.
The operation is successful according to the book instruction.
Why choose Xhorse Multi Prog Mastering Programming BOOK?
This 580+ page technical manual provides step-by-step bench instructions for locksmiths and ECU technicians.
- Hardware & Soldering:
Covers EEPROM, FLASH, and SRAM memory basics, SOP/MSOP package soldering (e.g., 93C66, 95128), and Multi-Prog software setup.
- IMMO & Key Programming:
Covers BMW E/F series key unlocking, IMMO dump writing for Land Rover RFA (MC9S12XEQ384), Audi BCM2 (D70F3381/3382), Porsche BCM, BMW EWS3/CAS3+/CAS4+, and VW MQB-LOCK dashboards (D70F3525/D70F3535).
- ECU Cloning & Repair:
Provides cloning steps for Bosch ME9.7, MED17.8.10, MD1CS089, and MEVD17.2.9 controllers, Renesas chip repair (R5F113TLL), Toyota sync editing, and built-in software tools (IMMO OFF, file conversion, data calculation).
Key Book Details
| Specification | Details |
| Compatible Hardware | Xhorse Multi-Prog Programmer |
| Total Pages | 586 Pages (check the first 15 pages) |
| Skill Level | Beginner to Advanced ECU Repair Technician |
| Core Topics | Soldering, EEPROM/FLASH Read-Write, IMMO Dump Calculation, ECU Cloning |
Using this practical book gives you verified pinouts and tested workflows, so you can handle ECU cloning and IMMO repair with confidence using Multi Prog ECU Programmer. It saves valuable diagnostic time and prevents accidental board damage during bench operations.
