OBDSTAR DC706 ECU Tool with ECM V31.42 can unlock ECU, read and write data, calibrate mileage and do IMMO off on BAIC Bosch ME7.8.8 ST10F275+ 95080 ECM by boot.
Preparation:
- OBDSTAR DC706 main unit
- Main cable
- High power stabilized power supply
- OBDSTAR ECU Bench Jumper
- MP001 multifunctional programmer
- BAIC Bosch ME7.8.8 ST10F275+ 95080 ECM
Requirement:
Make sure the ECM software is updated to V31.42 or above.
Ensure the internet connection is normal during the operation.
Operation guide:
ECU Flasher>> ECM>> ECM V31.42
Input me7.8.8 in the searching box to quickly find the corresponding ECM model (BAIC Bosch ME7.8.8 ST10F275+ 95080)
Click [Guide] to check the detailed connection method and operation instruction
Click [Pinout] and select “BOOT” and “MP001” adapter
Check [PCB Pinout]
Follow the soldering diagram to open the module cover and solder only GPT0 and GND points
Check [Connector Pinout]
Follow the wiring diagram to make the connection
| ECU | TOOL |
| A-Pin 12,13,44 | 12V (16) |
| A-Pin 00 | GND (4+5) |
| A-Pin 81 | CAN L (14) |
| A-Pin 62 | CAN H (6) |
| A-Pin 71 | K LINE (7) |
Connect MP001 Programmer and ME7.8.8 ECM via Bench jumper according to the diagram
Connect OBDSTAR MP001 Programmer and DC706 ECU Tool via the main cable
Connect the power supply to the main cable
After connection, click [Start], select “BOOT” and “MP001” adapter
Start to perform the related functions supported
1.Click “Connect” to connect ECU
2.Read INT flash and EXT eeprom
Read INTflash (ST10F275) and EXT eeprom (95080), and save the data separately
3.Write INT flash and EXT eeprom
Then load the external data (original INTflash and EXT eeprom) data to write into a new ECM
For INTflash, the ECU is in an unencrypted state, confirm to write directly
For EXT eeprom, need to verify the data
4.Calibrate mileage
Click “Mileage calibration”
The current mileage is identified. Enter the new mileage you want to overwrite.
Write data successfully
5.IMMO OFF
Click “IMMO OFF” and wait the process is completed
6.Disconnect
BAIC Bosch ME7.8.8 ST10F275+ 95080 ECM ECU Unlock, Data Read and Write, IMMO Off using OBDSTAR DC706 via Boot successfully.
Video Guide:
