OBDSTAR DC706 with ECM V30.61 (newest) can read and write Flash and EEPROM data for Smart EDC16C32, EDG15C-5.X KLINE, ME17.9.20 and ME7.7.0 KLINE ECMs on Bench. Some support Boot and OBD modes as well.
Check the support list below carefully.
BRAND | ECU BRAND | TYPE | DUMP | R & W INT flash | R & W INT EEPROM | R & W EXT flash | R & W EXT EEPROM | Other | COMM. MODE |
SMART | BOSCH | EDC16C32 | MPC561 (2) | √ | √ | BENCH | |||
SMART | BOSCH | EDG15C-5.X KLINE | 29F400BT+95P08 | √ | √ | BENCH/BOOT | |||
SMART | BOSCH | ME17.9.20 | TC1782 | √ | √ | Write VIN Reset (Virgin) |
BENCH | ||
SMART | BOSCH | ME7.7.0 KLINE | ST10F275+95080 | √ | √ | OBD/ BENCH |
How to read and write Smart ECM by OBDSTAR DC706?
i.e. SMART BOSCH ME17.9.20 TC1782
Accessories required:
- OBDSTAR Bench-A V3 cables
- OBDSTAR MP001 Programmer
- Main cable
- 12V 5A power supply (DC)
Function supported:
- Read& write INT Flash
- Read& write INT EEPROM
- Write VIN
- Reset (Virgin)
Operation mode:
On Bench
Step-by-step guide:
Select ECU Flasher>> ECM>> ECM V30.61>> ME17.9.20>> SMART BOSCH ME17.9.20 TC1782
Check the Pinout diagram, and connect DC706, MP001 Programmer and ECM via the corresponding cable correctly, connect the 12V power supply as well
ECU | TOOL |
C-Pin G1 | 12V (16) |
C-Pin H4 | GND (4+5) |
C-Pin A3 | CAN L (14) |
C-Pin A4 | CAN H (6) |
B-Pin H2 | GPT0 |
B-Pin J3 | GPT1 |
C-Pin D1 | IG |
After connection, click Start, and select BENCH and MP001
Make sure the internet connection is normal to perform the read and write function.
1.Conenct ECU
2.Read INT EEPROM and INT Flash separately, save the files after reading
3.Select the corresponding file of original ECM to write into a new ECM
4.We also can write VIN, and reset ECU by selecting “Reset (Virgin)”.
All read and write operations are easy and fast to operate with OBDSTAR DC706 ECU Tool.
Done!