Topic: Is it possible to clone BMW MEVD17.2.5 DME N13 Engine by CG FC200 ECU Programmer?
eobdtool.co.uk engineer has tested and confirmed it is 100% working by FC200.
Here is the related video:
STEP 1: Read and backup original ECU data
Open CG FC200 software
In the main interface, select Brand: BMW>> model: 3 Series (F30)>> ECU: BOSCH MEVD17.2.5 TC1797_N13>> Engine-gearbox: 316i N13B16A 136
Check the wiring diagram and follow it to connect CG FC200 and MEVD17.2.5 DME N13 Engine properly
Then go to Identify the ECU info successfully
Then read out the ISN is B27575E0EA53FD4F0DE0A4216C04A6D
Read DFLASH and PFLASH data in sequence, and backup the related file
Put the file into Fiardell HexCmp as shown as below
STEP 2: Read and backup new ECU data
Back to the FC200 software main operation interface
Identify another ECU info and read ISN
The ISN has been read out is 570298EC43DD022648E3224F481DE6CB
Paste the ISN to a new notepad
Then read and save DFLASH and PFLASH data as well
STEP 3: Write PFLASH
Click ‘Write PFLASH’
Data is about to be written. This operation will overwrite the original data of the ECU. Ensure that the data is backed up, then go to continue.
Open the original PFLASH file to verify is correct or not
If it’s incorrect, the system will prompt ‘File verification error, whether the file needs to be corrected (Warning: the wrong file may cause the engine to not work normally, it is recommended to correct it).
Click ‘Yes’ to continue
Ensure the network goes smoothly and wait patiently for a moment
Verify the file successfully
Erase and write data successfully
Read the ISN again, now it’s B27575E0EA53FD4F0DE0A4216C04A6D.
It’s the same as the original one.
Read and backup DFlash and PFlash data
STEP 4: Verify the ECU data
Finally, put the original file and the file to Fiardell HexCmp for comparison, both of them are the same.
OK, that means CG FC200 programmer successfully clones BMW MEVD17.2.5 DME N13 Engine.
