How to program Honda Motorcycle ICM proximity key by OBDSTAR X300 Classic G3?
Check all the goods required and the step-by-step guide below.
Preparation:
Main cable
M053 cable
12V DC power
OBDSTAR X300 Classic G3 Key Programmer
W004/W005 read/write soldering wire
C4-01 multi-function data read/write board
Honda motorcycle proximity Key (3- button key)
Honda motorcycle immobilizer control module (K48E5 type ICM with a single 33-pin connector)
Menu function path:
IMMO>> MOTO>> HONDA>> HONDA V40.22>> Manual Select System>> PROXIMITY TYPE 2 (33PIN SCU)
After manually selecting the system, you can click “Guide” at the left bottom to read the detailed operation steps and precautions.
Main steps:
Step 1: Select [Read pin from the original key]
Step 2: Select [All Keys Lost]
Step 3: Test Key
In detail…
Step 1: Select [Read pin from the original key]
Carefully review the prompts and the accessories required for reading the Pincode
1.Dissemble the SCU shell
2.Solder W004 and W005 to the SCU, and connect the line and equipment according to the wiring diagram (12V power supply+ OBD main line+ MP001 programmer+ C4-01 small board+ W004 programmer line (connected according to the corresponding color)+ SCU)
After the connection is complete, tap [Back] and begin to read the key info from the ICM.
Confirm the OBDSTAR MP001 programmer is connected to the X300 Classic G3
After the PinCode is read, you can see there are multiple keys in the current SCU. Take a screenshot or photo for future reference.
Step 2: Select [All Keys Lost]
Pay attention to the on-screen prompt and tap [Operation instruction] at the left bottom to view the wiring diagram and precautions for all-keys-lost programming.
Make connections according to the wiring diagram
The follow the prompt to switch all keys to the disabled mode, a new key can be programmed at a time.
Press and hold the key symbol button for 2 seconds, the LED lights are green for working mode and red for entry mode
Enter the IMMO Pin just read
Note: You must enter the PIN of an already enabled key to program successfully.
After key verification, switch the key to working mode.
Place this key next to the immobilizer box and tap [OK]
Key programming is completed.
Step 3: Test Key
Verify the present key is programmed by OBDSTART G3 Key Programmer successfully
Done!
