How to Correct Odometer for 35128WT with YH35XX Programmer & Simulator?

It’s easy to correct odometer for F classis 35128WT EEPROM and G classis VDO odometer with Yanhua YH35XX Programmer & Simulator, no risk and no red dot on odometer. Now the old chip clip is replaced by new YH35XX chip clip, making the chip installation, reading and writing easier and faster.

What is required?

YH35XX Programmer

YH35XX chip clip

Original car chip welding plate

Analog chip

Compatible analog chip

Original F classis 35128WT EEPROM/G classis VDO odometer

Computer/laptop (Win7/Win 10)

How to install YH35XX Chip Clip?

1.Confirm the position and pin definition of the original car chip welding plate, analog chip, compatible analog chip and YH35XX chip clip before installation

2. Tilt the original car chip welding plate, analog chip or compatible analog chip at an angle of 45°and install it into the corresponding YH35XX chip clip from top to bottom

3.Confirm that the original car chip welding plate, analog chip or compatible analog chip is firmly installed

4.Here is the overall installation effect.

How to change mileage with YH35XX Programmer & Simulator?

Step 1: Connect YH35XX programmer to PC

Step 2: Read and write 35128WT EEPROM Data

Step 3: Change 35128WT mileage

Step 1: Connect YH35XX programmer to PC

Remove the original chip from the odometer and solder it to the M35XXX original car chip welding plate

Connect YH35XX chip clip to YH35XX programmer

Install the original car chip welding plate into YH35XX chip clip

Plug the YH35XX programmer into the USB port of the PC, click “Computer” and it will recognize a USB flash drive named 35XX programmer

Click U disk 35XXprogrammer, and double-click “BMW_ODO_Standard_edition.exe” to open the software

When it appears “Programmer connection successful”, start to run it

Step 2: Read and Write EEPROM Data

Select the EEPROM model and click “Read DATA+ID”, then check whether the read mileage is the same as the actual mileage

Click “Save Data File” to save the original data of the original EEPROM to the folder

Take out the original car chip welding plate, and replace the simulator

Connect the analog chip or compatible analog chip into YH35XX chip clip correctly

Select EEPROM model, click “Load Data File”, select the corresponding data of original EEPROM and load it, then check whether the displayed mileage is the same as the mileage displayed in odometer

Once the mileage is confirmed, click “Write DATA+ID”, and write the original data into the Simulator

Click “Read Data+ID”, read the data written into the Simulator, and check the mileage

Step 3: Change 35128WT mileage

After the mileage is confirmed, click “Mileage modification” and input the mileage you want

After the input mileage is confirmed correct, click “Write DATA+ID” to write the modified data into the Simulator

After the data is written, click “Read DATA+ID” to check whether the mileage modification is correct

If the displayed mileage is the same as what you want, cut the handle of the simulator and solder it back to the original EEPROM position. Pay attention to the EEPROM direction. Install the odometer back into the car to verify whether the mileage modification is successful.