SEC-E9 cut T60 keys by using the dimple key clamp

How to use SEC-E9 to cut T60 keys by using the dimple key clamp?

Here is the step-by-step guide for sec-e9 key cutting machine owners.

Device:

SEC-E9 key cutting machine

T60 key

Blank new key

Steps to cut T60 keys by SEC-E9

Step 1: Decode original key number 

Press the “Dimple” button and select “T” “Teas” “T60” to enter the key data

Press “Decode”, then the original key can open cylinder

Fix the original key on top level of the dimple clamp

Note: Please pay attention to the key position

Press “Decode” button to start decoding original key and get the key numbers

Press “Cut” button to enter cutting page

Step 2: Cut new blank key

Fix the new key blank on top level of the dimple clamp

Please pay attention to the key position

Press “Cut” button to start cutting a new key (side A) with SEC-E9

Note: Please remember to close the safe gate

Done with side A

Open the safe gate to clean the clamp& the new key

Then take out the new key

Put side B on the dimple clamp, pay attention to the key position

Repeat the same above operating step as side A to cut side B

Cutting is done!

Open the safe gate to clean the clamp& the new key

Remove the new key

Test the new key, work very well!

 

eobdtool.co.uk