Self- learning Tire Pressure Sensor (TPMS) for BMW/VW

Eobdtool.co.uk has released BMW/ VW self-learning tire pressure sensor. They can be used when the original tire pressure sensor is damaged/doesn't work/ cannot be matched and activated again / the battery is low and the display value is incorrect. It doesn’t require the device to activate when using BMW or VW self-learning tire pressure sensor. Just install it on the car and follow the self-learning steps to complete matching and activation. It can monitor the current tire pressure & temperature, and provide a safety guarantee for the driver.

There are three types of BMW TPMS Car Tire Pressure Monitoring System.

• TYPE-BMW1-433 (Item  No. SO585)
• TYPE-BMW2-433 (Item  No. SO586)
• TYPE-BMW3-433 (Item  No. SO587)

src: https://www.eobdtool.co.uk/wholesale/bmw-tpms-sensor.html

The prices of three types are €19.99 free shipping.
The main difference among them is the BMW car models supported are different.

There are two types of VW TPMS Car Tire Pressure Monitoring System.

• TYPE-VW1-315 (Item  No. SO588)
• TYPE-VW1-433 (Item No. SO589)

src: https://www.eobdtool.co.uk/wholesale/tpms-tire-pressure-monitoring-system-for-vw.html

The prices of two types are €19.99 free shipping.
The main difference between them is the VW car models supported are different.

Why need to install VW or BMW Self-learning tire pressure sensor?

1.Foresee air leakage: When air leakage reaches a dangerous level, the TPMS system will issue an alarm.
2.Prevent tire blowouts: Real-time monitoring of tire pressure and temperature, when abnormal TPMS occurs, the system will alert you.
3.Prevent tire bulge. Tire pressure overheating and high pressure may cause tire cord breaking and rubber aging.
4.TPMS sensor can monitor the current tire pressure and temperature in real time for 24 hours.
5.Standard tire pressure and temperature can extend the life of the tire.
6.Provide safety guarantee for users to trip.

The advantages:

• No need for professional tools to match and activate the TPMS.
• Easy to install.
• Dustproof, waterproof, cold resistance and aging resistance, support tires running at high speed, high airtightness.
• Support high-speed self-learning.
• You only need to replace the broken tire sensors, not all four tires before matching and activation. It is compatible with the original TPMS sensor without causing the TPMS system to work abnormally.

How to install BMW or VW Self-learning tire pressure sensor?
1.Dismantle the tire
2.Take off the TPMS sensor of the original car

3.Install BMW or VW Self-learning tire pressure sensor

4.Inflate the tires and install them on the car, prepare for self-learning

Self-learning steps for BMW:
1).Start the engine.
2).Locate the “TPMS RESET” button at the end of the handle and press until you are prompted to reset the tire pressure information.
3).Drive at a speed of no less than 30Km/h (20mph) to ensure that the vehicle enters the new ID recognition mode of the tire pressure sensor. (Try not to stop in the middle.)
4).To ensure that the new tire pressure sensor is correctly identified, at least 20 minutes of driving is required.
5).Enter “My Vehicle”-> Select “Vehicle Status”-> “Perform reset”

It will do self-learning when driving.
When reset successfully, it will prompt “Tyre Pressure Monitor active.”

Self-learning steps for VW:
1).Engage parking brake.
2).Turn ignition ON (engine off).
3).Select CAR/RESET to display TIRE PRES. MONIT. WHEEL CHANGE.
4).Press RESET/STORE.
5).Drive up to 20 mins.
6).Set tire pressure.

Something important to know during the BMW or VW self- learning TPMS:
1.The driving speed cannot be lower than 30Km/h (20mph)
2.Need to drive the car to the relatively unobstructed road section (about 20km, with fewer traffic lights and few stops, which can improve the success rate of self-learning, usually it will take 6-20 minutes. Too many stops on the road will lead to learning failure, and then drive the car on the unobstructed road section to relearn.)
3.The inflation pressure cannot be too high or too low. Must comply with the tire pressure set by the vehicle TPMS.
4.It covers the year when the car was manufactured, not the year when the customer bought the car.
5.It is suitable for users who installed TPMS sensor in the car, and need to replace the broken TPMS sensor.

If it fails to learn TPMS, how to solve?
Problem 1: The speed is lower than 30Km/h (20mph).
Solution: Control the speed

Problem 2: During the driving, there are too many pauses.
Solution: Drive to the road in good conditions to re-learn.

Problem 3: In addition to the TPMS sensor of the original car, a third-party TPMS sensor is installed
Solution: Remove the third-party TPMS sensor

Problem 4: The tire pressure does not meet the calibration value of the car
Solution: Adjust tire pressure

Problem 5: Doesn't support the year model
Solution: Use it on a supported vehicle

Check the specific car models supported as below.

www.eobdtool.co.uk