With the release of X-431 ECU Clone Software V10.75, Launch X-PROG5 now supports BENCH mode reading and writing for locked BMW and MINI MD1 and MG1 engine control units (TC298 chips, manufactured post-2020.06). Below is the complete list of supported… Continue Reading
Launch officially released the new X-431 ECU Clone software V10.75 on September 21, 2026. This update enables locked BMW/VW Bosch MG1/MD1, RH850 chip reading (Bench/Boot mode), Fiat MB91 IMMO parsing, and Continental SIMOS18.x BOOT cloning, etc features for X431 X-Prog5, X431 ECU &… Continue Reading
Launch has finally streamlined their key programming and ECU cloning lineup with the all-new X431 X-PROG5 (G5). If you are tired of the old X-PROG 3 cable clutter or limited transmission cloning support, G5 is the all-in-one tool you’ve been waiting for.… Continue Reading
Use the Launch X-PROG3 PC Adaptor and X431 X-Prog3 to clone Buick E83 engine computer on bench, works like a charm! Connection diagram: Device connection: Full connection: Run X-PROG3 PC Adaptor PC Software Note: For the first time using,… Continue Reading
Use the Launch X-PROG3 PC Adaptor and X431 X-Prog3 to clone Infiniti VGS2-FDCT gearbox computer on bench, works like a charm! Here is the operation process: Connect the X-PROG3 PC ADAPTOR to the computer using a USB cable, and… Continue Reading
How to use Launch X431 X-Prog3 PC Adapter and X431 X-Prog3 to clone VW DQ200 Transmission Computer? Check the test on a VW Ameo 2016 DQ200 TC1766. Procedure: 1.Download and install X-Prog3 PC Adapter PC Software 2.Connect the X-PROG3 PC ADAPTOR… Continue Reading
Launch X431 X-Prog3 PC Adapter can work with X-prog3 Immobilizer & Key Programmer to clone VW DQ200 successfully. PC software is required. Here takes 2016 Audi Q2 DQ200 (0AM/0CW) as an example. Step 1: Download and install X-Prog3… Continue Reading
