FGtech V54 read and write SF10Fxx (K-Line) via Tircore Boot Mode

I have tested some other models: EDC16U1 (VAG) Read/Write ok (OBD) EDC15V (VAG) Read/Write ok (OBD) Audi A6 (TRICORE BOOT) E70 3.0D EDC16 (BDM) Renault Delphi 2007 k-line I use FGtech V54 want to read and write SF10Fxx (K-Line) via Tircore Boot… Continue Reading

K-TAG KTM100 V2.13 Firmware 7.003 new add EDC17 ECUs

The newly launched KTAG V2.13 KTM100 Firmware V7.003 ECU programmer adds some vehicle model EDC17 ECUs, please check below: BMW EDC17C41   TC1797 EDC17CP45  TC1797 EDC17C50   TC1797 EDC17C56   TC1797 EDC17CP49  TC1797 MEVD172G  TC1797 MEDV1725   TC1797 VW  EDC17C46   TC1797 EDC17C44   TC1797 MED17.1.6   TC1797 MED17.5.21 … Continue Reading

How to use kess v2 v2.22 master ECU Chip Tuning ?

Kess V2 Vehicle List Download: http://www.eobdtool.co.uk/upload/pro/kess-v2-obd2-tuning-kit-vehicle-list.xls Attention: Pleas do not update Kess V2 China clone online. Notes: 1. Be sure that Anti-Virus software is disabled or closed Please be attention,anti-virus software will treat our KESS V2 OBD tuning software as… Continue Reading

FGTech “Can not find driver” problem what to do?

Problem: When install FGTech Galletto 2, the FTReadWrite replied “Can’t find device” error message. When trying to uninstall the driver, the window screen warmed it is not FGTECH device, but USB-to-Serial device. If install the driver, fgtech software did not run and FTReadWrite or MProg didn’t find the ftdi chip. Try to install the driver on both win 7 and win xp computer over and over, but in vain. Solution: 1) Download and install the Virtual Com Port drivers from FTDI website: Virtual COM Port Drivers http://www.ftdichip.com/Drivers/VCP.htm 2) Then connect the FGTech to computer via USB port which had no device programmed and 1 blank device when the MProg Utility it shows. NOTE: If you had backup and reprogram with the ept file. The system will not recognize the FGTECH Galletto 2 and will not reprogram the firmware bin file. The Virtual Com Port Drivers would overlay the fgtech ECU programmer. Then you have to again download the related driver in FTDI website. CMD Uninstaller 1.4 http://www.ftdichip.com/Support/Utilities.htm 3) After install the right drivers, FTReadWrite programmed the backup firmware file, run FGTech software by referring to the user manual on obd365 webpage. www.eobdtool.co.uk here offers some FGTECH related files download.

V2.13 KESS V2 Software Installation Notice and Guide

Newest V2.11 software for KESS V2 has been just launched for a short period of time, and now obdtoolshop offers you the lastest V2.13 KESS V2, attached with lastes V2.13 softare. Software Version: V2.13 Hardware Version: V 4.036 Pre-installation Important Tips: 1. Disable Internet connection and PC/Laptop CANNOT have… Continue Reading