Foxflash ECU Chip Tuning Tool adds a new exclusive protocol in the newest software on May 23, 2023. After upgrade, you’ll find the BENCH protocol for Isuzu EDC17C83. Foxflash update info: Bench/Boot protocol for Isuzu EDC17C83. Supported Control Units… Continue Reading
Confirmed! OBDSTAR DC706 with ECM V30.07 (newest software) can clone Jeep and Fiat IAW 10GF ECMs on Bench perfectly. OBDSTAR P003 Adapter, 12V power, and internet are required. Make sure the internet connection is normal during the operation. 1.OBDSTAR… Continue Reading
Here shares the solution to fix foxflash error “EXECUTE DOWNLOAD WITH DFBTech_UPDATER FOR TOOL RE-ESTABLISHMENT” when downloading the software to a new computer. The solution: Make sure the following items are performed: 1. Turn off Defender 2. Set Date/time… Continue Reading
OBDSTAR MT200 is a portable and cost-effective handheld radio decoding tool to perform EEPROM read & write, code read & change & off and other functions by OBD or Bench for Ford, VW, etc. The Pincode of Radio can be… Continue Reading
Foxflash ECU Chip Tuning Tool can support JTAG/BDM mode for Denso ECUs reading and writing. Just need to open the ECU and connect it with the JTAG/BDM adapter. Sometimes, it cannot work normally. The possible cause is the ribbon cable… Continue Reading
The Foxflash ECU Programmer can support FCA GPEC2 GPEC3 GPEC4LM GPEC2A ECUs read and write in Boot mode since March 14, 2023.Click here to check the detailed ECU models. Today we’ll share the Pinout to these ECUs. BAM SPC5674… Continue Reading
Is it possible to use Foxflash ECU Programmer to read and write Renault sid310? via OBD, bench or boot? Here is the answer. OBD and Boot mode both are OK. 1.OBD Driver for Renault Master SID310 is available… Continue Reading
Here are three new problems and solutions for Foxflash ECU Programmer. Problems: Problem 1: Value of 25/9/2022 is not valid for “Value” Problem 2: The application was unable to start correctly Problem 3: An error occurred while trying to… Continue Reading
xDecoder program allows you to find the error, in just a couple of clicks on the firmware file. You need to disable it with the DTC off error mask. xDecoder v10.3 software info: Date: 07/24/2022 Version: 10.3 Available in:… Continue Reading
The newest Foxflash software is released on March 14, 2023. Now it is able to perform the Continental GPEC2 GPEC3 GPEC4LM GPEC2A ECUs read and write in Boot. Update method: Try to update just connect, run Foxflash Manager and… Continue Reading
Some customers ask how to use Foxflash ECU programmer to clone Benz VGS3, Audi MED9.1, and VW MED17.1 successfully. Here are tips offered by eobdtool.co.uk engineer. 1.For Mercedes- Benz VGS3 (on bench) Use FoxFlash to copy the VIN and… Continue Reading
