How to use CG100 Prog III or CGDI CG100X Programmer to repair BMW FRM3 Footwell module?
Check the details below.
The FRM3 Footwell Module is commonly found in the following vehicles:
BMW: E81, E82, E84, E87, E89, E90, E91, E92, E93, E70, E71, E72 series.
Mini: R55, R56, R57, R58, R59, R60, R61 series.
If the FRM module is faulty, you may encounter these issues:
- Light switches do not respond.
- Windows fail to go up or down.
- Some lights, such as parking lights, remain constantly on.
- Indicators stop working.
- Interior lights fail to turn on.
How to repair FRM Module by CG100/CG100X?
CG100 and CG100X are excellent tools for repairing BMW FRM modules. While other programmers like VVDI Prog can read and write data, CG100 is specifically designed to repair the module.
Here’s a step-by-step guide:
Open the FRM module and remove the circuit board.
Use a special FRM clip adapter to connect the FRM module to the CG100 programmer.
Alternatively, you can use a CG BMW FRM Solder-free Adapter (recommended) or solder wires manually.
Connect the FRM module to the CG100 using the BDM4 adapter.
In the software, navigate to:
BCM>> BMW>> FRM>> E Series>> 9S12XEQ384 (3M25J)
Confirm the connection and press Start to read the data.
Connect a reliable power supply.
Ensure the voltage remains stable and does not drop.
Successfully read the chip’s D-Flash data.
Save and Repair
Turn off the power supply after reading.
Save the data file when prompted.
The CG100 will ask if you want to repair the FRM module—press “Yes”.
The repair process will begin automatically.
Wait for the process to complete. Do not disconnect during the repair.
Write the repaired EEPROM data back to the FRM module.
The FRM3 module will be successfully repaired and ready to reinstall in the vehicle.
Done!
